Can You Apply Floor Coating Over Old Concrete? Yes—Here’s How - Etepox Solution Sdn Bhd

Yes, you can apply floor coating over old concrete—as long as the surface is properly evaluated and prepared. In fact, restoring old concrete with the right coating is a cost-effective way to extend its life, improve safety, and enhance appearance.
Here’s a complete guide on how to do it right:

Can You Apply Floor Coating Over Old Concrete?
Yes, but only if:

The concrete is structurally sound (no severe cracking or crumbling)
It's clean, dry, and free of contaminants (like oil, grease, or sealers)
Surface preparation is done correctly (grinding, shot blasting, or scarifying)

Step-by-Step: How to Apply Floor Coating Over Old Concrete
1. Inspect the Concrete

Check for:
- Cracks, spalls, or surface damage
- Moisture issues (efflorescence, dampness, water seepage)
- Old coatings or sealers that could prevent adhesion

Tip: Tape a plastic sheet to the floor for 24 hours. If moisture forms underneath, you may need a moisture barrier or vapor control primer.

2. Repair Any Damage

Fill cracks with epoxy crack filler or polyurethane joint sealant
Patch spalled or pitted areas with a concrete repair mortar
Grind down high spots or uneven patches

3. Prepare the Surface

Use diamond grinding, shot blasting, or scarifying to:
- Remove old coatings, sealers, laitance
- Open the surface for mechanical adhesion
Vacuum thoroughly to remove dust and debris

The surface should feel like 120-grit sandpaper.

4. Prime the Surface (Optional but Recommended)

A good epoxy or polyurethane primer:
- Improves adhesion
- Seals pores in old concrete
- Helps bond the topcoat more effectively

If the floor has high moisture, use a moisture-tolerant primer or vapor barrier epoxy.

5. Apply the Floor Coating
Choose the coating type based on the area’s needs:

Coating Type	Ideal For
Epoxy	Garages, warehouses, dry processing areas
PU (Polyurethane)	Commercial kitchens, labs, areas with thermal shock
PU-Cement	Food processing, wet zones, high-impact floors
MMA	Freezers, fast-turnaround areas

Use rollers, squeegees, or notched trowels depending on product specs
Apply in even layers—typically 1–3 coats
Allow proper curing time (usually 8–48 hours before foot traffic)

6. Optional Add-Ons

Anti-slip aggregates for safety
Topcoat for UV resistance or gloss control
Color flakes or quartz for decorative appeal

Summary Checklist
Concrete is structurally sound
Repairs and cracks are addressed
Surface is ground or blasted for adhesion
Primed (especially if old, porous, or damp)
Coating applied according to specs
Proper curing time observed

Common Mistakes to Avoid

Skipping surface prep
Applying over dirty or oily surfaces
Ignoring moisture issues
Choosing the wrong type of coating for the environment

Final Thoughts
Refinishing old concrete with a floor coating is entirely doable, and can transform aging floors into seamless, durable, and hygienic surfaces—perfect for industrial, commercial, or even residential settings.

Nama Penuh *
Emel *
Nombor Telefon *
Nama Syarikat
Alamat Syarikat
Tajuk *
Bagaimana kami membantu anda? *