-
How to install acrylic hot wheel rack
How to install acrylic hot wheel rack
- Identify the staircase and support.
- insert the staircase into the slot in support
- make sure the bottom (no slot hole) is at the bottom
- repeat until it’s done!
Category by How To Install Acrylic Hot Wheel Rack -
How to Install Self Assembly Acrylic Cabinet
How to install Self Assembly Acrylic Cabinet- Identify the Plates name, TOP LEFT RIGHT BOTTOM FRONT BACK
- Remove the protective sticker.
- Screws the connector to acrylic correctly based on their name.
- IMPORTANT: MAKE SURE DO NOT SCREW TOO TIGHT.
- Before screw TOP plates, install the door aluminium (If you are buying sliding door version)
- Put in the door, only screws the TOP PLATES
- Tighten all the screws. DONE.
-
How to install Self Assembly Lucky Draw Box
How to install Self Assembly Lucky Draw Box- Identify the plate name
- Peel off the sticker and assemble following the plate name
- Screw the interconnector in the inside of the box. The screws should be at the outside. (Make sure it is not tight when screw)
- Make sure all the plates are assemble correctly, tighten the screws with a screwdriver.
-
How to Install (Hanging type)House Number Plate
How to Install (Hanging type)House Number Plate- Use the given acrylic to do marking
- Drill hole with 6mm drill bit
- Install the screw anchor
- Install the screws (leave some space from the wall)
- Hang the signage
-
How to Install with Signage with tape
How to Install with Signage with tape- Clean the wall (Make sure no dust)
- Make sure the surface is flat and smooth
- Peel off the tape cover
- Align to correct position and stick on your wall
- Press it for 5 seconds to improve adhesion
-
How to Install with Screws and Sign Spacers
How to Install with Screws and Sign Spacers- Marking the holes to drill on wall.
- Use 6mm drill bit to drill holes on wall.
- Insert the screws anchor.
- Screws the sign spacers into the wall
- Lock the signage/ house number plate using the sign spacer
-
Installing a Solar Lamp on House Number Plate
Installing a Solar Lamp on House Number Plate- Use the screws given to install the lamp on the plate
- Make sure the holes are correct.
- Can use double sided acrylic tape to install too, result will be as stable as using screws.
- Remember to turn on the lamp before install.
-
How to Turn on the Solar Lamp for House Number Plate
How to turn on the solar lamp for house number plate- Use the given pin to poke the hole on the lamp
- If pin is missing, can use handphone pin / any pin to poke too.
- Once turn on, it should light up in dim environment and turn off when under sunlight (the solar panel is Charging battery)
- Remember to turn on the lamp before install the house number plate on your wall.
-
How to Install a Transparent Cashbox
You said:
ChatGPT said:
You said:
ChatGPT said:
-
How to Install a Prayer Mat Holder
How to Install a Prayer Mat Holder
-
Ensure all prayer mat holder components are complete and in good condition.
-
Mark the installation spot on the wall or chosen surface.
-
Use a measuring tool or level to make sure the marks are straight.
-
Drill holes at the marked points (if required).
-
Insert wall plugs into the drilled holes (if provided).
-
Secure the prayer mat holder using screws and tighten with a screwdriver.
-
Check to ensure the holder is firmly and securely installed.
-