Battery powered datalogger with 4 universal inputs for measurement of 0-10V voltage, 0-20mA current, two-state signal and for counting pulses.
Signals are connected to four detachable terminal blocks.
Multilogger can be installed permanently to Ethernet network or work as portable device.
Included is traceable calibration certificate in accordance with EN ISO/IEC17025.
The Multilogger is a battery operated datalogger capable of measuring and recording sensor and electrical values through its Inputs.
Datalogger can be connected to Ethernet. Then measured values can be viewed on a web browser, as well as stored and downloaded for later analysis.
-
CodeM1300
-
Warranty3 years
TECHNICAL DATA
MEASURED VALUE
CurrentVoltageTwo-state signalPulsesDC VOLTAGEMeasuring range 0 to 10 VAccuracy ±10 mVResolution better than 100 µVDC CURRENT
Measuring range 0 to 20 mAAccuracy ±20 µAResolution better than 0,1 µABINARY SIGNAL
Input voltage for level “switched on”/ <0,4 V/> 2 VMinimum/maximum input voltage 0 V/+30 V DCI mpedance of the “switched on”/ < 10 kOhm/> 300 kOhmCOUNTER INPUT
Range of counter 24 bit (16 777 215) the counter overflow can be allowedMaximum input frequency 200 HzGENERAL TECHNICAL DATA
Operating temperature -10 to +60 °CChannels 4x binary, counter, voltage and current inputMemory 1 000 000 values (noncyclic record), 600 000 values (cyclic record)Recording interval 1s to 24 hoursDisplay and alarm refresh each 10 sRecording mode noncyclic - data logging stops after filling the memory
cyclic - after filling memory oldest data is overwritten by newAvailable temperature units degrees Celsius, degrees FahrenheitCommunication interface Ethernet, USB, RS232Ethernet communication protocols WWW, SNMPv1, XML, DATALINKAlarm protocols E-MailPower AC adapter 230Vac/5Vdc (neccessary for Ethernet interface)Battery life 3 - 4 weeksProtection class IP20Dimensions (without connectors) 178 x 95 x 37mm, without attached cablesWeight (including batteries) approx. 380 gWarranty 3 years