(MFS-R12) Material Analysis of Powders, Ferrous & Non-ferrous Metals Spectrometer

Also the analysis of solutions after evaporation is possible.

*For spectrometer operation argon is not required. However, as a result, it does not provide the analysis of sulphur and phosphorus in ferrous metals.

The use of reliable and trusted components ensure good accuracy and stability... Is why MFS-R12 is an excellent spectrometer for material analysis.

(Technical Specification & Software Details, are down below).

Optical System

Optical system is a well-proven 500 mm Paschen-Runge. In order to ensure spatial stability of the spectrum, all the optical elements are installed on a stable cast-iron platform.

Light detectors are linear CCD arrays, specially mounted without blind zones, allowing to record analytical signals from the entire spectral range.

Compared to separate spectral lines measurements using photomultiplier tubes, CCD arrays provide virtually unlimited analytical capabilities in a single instrument.

Sample Stand

Original sample stand construction allows use to analyse:

• Samples of any shape.
• Rods and wires.
• Powders: ores, oxides, ferroalloys, slags, etc..
• Solutions (with prior evaporation).

Closed-cycle water cooling system eliminates any sample stand heating effects.

Doesn’t require argon purge for operation.

Excitation Source

Compact computer controlled low voltage spark source. Discharge current amplitude and waveform, as well as pulse duration and repetition rate are adjusted in a wide range, what makes it possible to analyze various metal and non-metal samples.

Full computer control of the generator allows to:

• Chose the optimum excitation parameters.
• Switch between different discharge modes in a single analytical exposure (one can use up to 5 different modes including High Energy PreSparking ).
• Use programmable current peak at the discharge front.
• Automatically set up generator parameters for every analytical program.

All these features improve accuracy and precision of the analysis and advance performance of the spectrometer.

Readout System

Readout system provides spectrometer control, testing & analytical signals measurements. This Spectrometer has the most modern electronic components, thus reducing size, power consumption and heating. Due to the high speed USB interface, all the 40,000 spectrum data points are transferred to the computer almost instantly.

WinCCD Software

Spectrometer is controlled by personal computer and user friendly WinCCD software.

WinCCD allows to get complete control over the spectrometer, perform calibration and analysis without any special training. WinCCD contains numerous functions for spectral data processing as well as analytical tools, previously developed in our WinQuant software.

MFS-12 is an easy to use spectrometer with friendly WinCCD software. Stable optical system, computer controlled excitation source and practically unlimited analytical lines selection provide good precision and long term stability of your measurements.

MFS-R12 Specification

Spectrometer design: Pashen-Runge

Focal length: 500 mm

Spectral range: 190-425 nm

Detectors: 10 linear CCD arrays, 3648 pix each

Sample stand: Original construction allowing to analyze various shaped samples and powders

Excitation source: Computer controlled low voltage spark.

Analysis:

Requirements:-

Ambient temperature: 15…250С

Relative humidity: <= 80%

Power supply: 220 V (±10%), 50 Hz, single phase with protective ground

Electrical power: Max. 2.5 kVA.