Laying Of Rubber Buffing

Distribution

Mixing Of Binder

Mixing Of Binder

Mix binder and buffing properly and later spread rubber buffing at equal portions throughout the surface. Maintain the ratio of binder and rubber buffing throughout the process. Otherwise, the layer could be too hard or too soft.

Commence design marking with chalk after the rubber buffing layer is semi-dried. The design could be anything and make sure it is not too complicated. The marking is important as different coloured granules can be easily applied.

EPDM granules are mixed thoroughly with a binder and laid as per design. Maintain a proper ratio of granules and binder in this process. After that, they are levelled with the tapping of a wood trowel and screed.

After completion, the flooring will be kept idle for 4 to 5 days depending on the weather.