吉隆玻锟斤拷TRIAC & PWM Multi-function Dimmer 0-10V

1) AC input: 90V-240V 50Hz / 60Hz

2) Output channel: 2 channel(PWM/0-10V+AC)

3) 0-10V PWM +Trailing edge dimming

4) Compatible with above 95% PWM driver,0-10V driver and triac driver

5) 0-10V PWM dimming current: 200mA

6) AC output current: 1A

7) AC output power: 200W .

8) RF frequency: 433MHZ

9) Control mode: RF remote

10) Remote distance: under the condition of without disturb, 20 meters.

11) Fixed grey output

12) 0-100% brightness dimmable, no twinkling

13) Power output can be cut off

14) No noise, no radiation

 

2. Use instructions

1) The input voltage of this controller should to be AC90V-240V.

2) Never connect two wires directly in case of short circuit.

3) PWM switch is use for choose 5V or 10V PWM signal according your led PWM driver, default setting is

10V PWM.

4) Pairing code: short press ''Study'' key, then LED will be slow flash, and then press any key of remote controller, LED will be off when it is paired successfully. Cancel code: long press ''Study'' key for five seconds, then LED lighting will be fast flash for 8 time, then code cancel successfully. One controller can match eight remote.

5) long press ''brightness+'' and ''brightness-'' for quick dimming.

 

3. Key instructions of Remote and Connection instructions of Controller














The dimmer effective power is about 80%, so please make sure dimmer power overstep 20% than led load when you choice. Please touch the motherboard while dimmer is connecting to AC power, and setup must according technical guide.