新加坡Mobicon-Remote Electronic Pte Ltd的Transmitters and Regulators - Comet-Comet H4531 - thermometer with Ethernet interface and relays

code: H4531
Temperature Ethernet sensor for Pt1000 sensors with two relay outputs.

Sensor H4531 is designed for online monitoring of temperature. Three binary inputs to detection of two-states signals are the advantage. Other devices are controlled by two relay outputs.

Included in delivery:

H4531 sensor
Traceable calibration certificate
Quick start manual
Technical support at discussion forum

Technical parameters	Value
Output	Ethernet
Measured Value	Temperature
Construction Type	For External Temperature Probe Pt1000
Design	Industrial
Temperature Measuring Range	-200 to 600 °C
Relay Output	Yes
Two-State Input	Yes
Lcd Display	Yes
PoE	No
Accuracy of temperature output	±0.2°C (without temperature probe)
Resolution	0.1°C
Measuring interval	2s
Available temperature units	degrees Celsius, degrees Fahrenheit
Temperature operating range	-30 to +80°C
IP protection	IP40
Number of relay outputs	2
Maximum switching voltage, current and power of relay output	50V, 2A, 60VA
Number of binary inputs	3
Signal for binary inputs	dry contact, open collector or two-state voltage signal. Inputs are not galvanically isolated.
Minimum pulse length at binary input	500ms
Low voltage level at binary input	0 to +0.5V
High voltage level at binary input	+3.0 to +30V
Audible alarm	built-in beeper - switchable
LAN connection	RJ-45 connector, 10Base-T or 100Base-TX
Communication protocols	WWW, ModbusTCP, SNMPv1, SOAP, XML
Alarm protocols	E-mail (SMTP authentication is supported), SNMP Trap, Syslog
Configuration	WWW interface, T-Sensor
Temperature operating range of LCD display	readable to operating temperature +70°C, it is recommended to switch OFF the LCD over +70°C
Power	9 to 30Vdc, maximum consumption 1W
Power connector	co-axial, diameter 5.5 x 2.1mm
Probe type	Pt1000/3850, shielded cable maximum length 10m
Dimensions	136 x 160 x 45mm (W x H x D)
Weight	approximately 340g