| Image chip type | Monochrome |
| Light spot size [mm] | 2 x 5
|
| Explanation of light spot size | une distance de 150 mm
|
| Switching frequency ≤ [Hz] | ≤ 100
|
| Light source | LED
|
| Light color | Red |
| Wavelength [nm] | 625 |
| LED risk category [RG] | 0 |
| Explanation of risk category | Nach EN 62471
|
| Projector laser | Laser red (635 nm), Class 2 (IEC 60825-1)
|
| Resolution | HDV2 |
| Number of pixels (H x V) [px] | 1440 x 1080
|
| Imaging chip technology | CMOS |
| Sensor size ["] | 1/2.9
|
| 3.45 |
| Field of view type | Medium
|
| Focal length [mm] | 12.0 |
| Opening angle [°] | 24.0 |
| Min. field of view (X x Y) [mm] | 10 x 8
|
| Aperture number | 2.8 |
| Depth of field | Standard |
| Focus drive | Motorized |
| Target laser | Laser rot (655 nm)
|
| Laser class | 1 (IEC 60825-1)
|
| Network protocol | TCP/IP, Profinet, EtherNet/IP, sFTP, SMB, FTP, Service Port
|
| Max. number of jobs | 255 |
| Max. number of detectors | 255 |
| Alignment | Contour comparison, Pattern matching, Edge detection
|
| Available detectors | Pattern matching, Contour, Contour (3D), BLOB, Target mark (3D), Data code, advanced, Barcode, advanced, OCR, Brightness, Contrast, Gray level, Caliper, Distance
|
| Result processing | Text, Numbers, Robotics
|
| Pre-processing | Arrangement, Filter
|
| Calibration | Board (measurement), Board (robotics), Hand-Eye (robotics), Base-Eye (robotics), Scaling (measurement), Point pair list (robotics)
|
| Robotic functions | Gripper clearance check, Result offset, image coordinates, Result offset 2D, Result offset 3D
|
| Additional functions | Archiving, Image transmission, individual overlays, Multiple image acquisition, Multiple detection for contour and pattern matching detector, Multiple detection for detector contour (3D), Job checksum, Conditional executions
|
| Available detectors | Pattern matching, Contour, Contour (3D), BLOB, Target mark (3D), Data code, Barcode, OCR, Brightness, Contrast, Gray level, Caliper
|
| Hardware | VISOR
|
| Warm-up time [Min.] | 20 |
| Temperature profile [mm/K] | 0.01 |
| Typical current draw [mA] | 350 |
| Type of voltage source | The device must be supplied by a "Class 2" power supply unit.
|
| Readiness delay [ms] | ≤ 16,000
|
| Reverse polarity protection | Yes |
| Overvoltage protection | No
|
| Residual ripple [%] | ≤ 5 Vss, level 3
|
| Explanation of residual ripple | EN 61000-4-17
|
| Polarity | PNP/NPN
|
| Short circuit protection | Yes |
| Input threshold (High) | > UB-1V
|
| Input threshold (Low) | < 3V
|
| Input resistance [kΩ] | > 20
|
| Max. output current [mA] | 50 |
| Explanation of max. output current | max. 100 mA on pin 12
|
| Inductive loads | Typ.: Relay 17 K / 2 H, pneumatic valve 1.4 K / 190 mH
|
| Max. output current (total) [mA] | 200 |
| Ethernet transmission rate [Mbit/s] | 100 |
| Number of switchable IOs | 6 |
| Number of outputs | 2 |
| Number of inputs | 2 |
| Encoder functions | Yes |
| Height [mm] | 85.0 |
| Length [mm] | 45.0 |
| Width [mm] | 76.4 |
| Weight [g] | 490 |
| Front panel material | PMMA |
| Housing material | Aluminum (cast)
|
| Connection name | Supply |
| - Number of pins | 12 |
| - Coding | A |
| - Thread | M12x1
|
| - Material | Metal |
| - Type | Plug
|
| Connection name | LAN |
| - Number of pins | 4 |
| - Coding | D |
| - Thread | M12x1
|
| - Material | Metal |
| - Type | Socket |
| Explanation of ambient temperature: storage | < 95 % humidity, non-condensing
|
| Protection class | IP 65, IP 67
|
| Explanation of protection class | For C-mount devices, only in combination with protective tube
|
| Explanation of protection class | For C-mount devices, only in combination with protective tube
|
| Vibration and shock resistance | EN 60068-2-6, EN 60068-2-27
|
| Height [mm] | 85.0 |
| Length [mm] | 45.0 |
| Width [mm] | 45.0 |
| Weight [g] | 220 |
| Front panel material | PMMA |
| Housing material | Aluminum (cast)
|
| Explanation of ambient temperature: storage | < 95 % humidity, non-condensing
|
| Protection class | IP 65, IP 67
|
| Explanation of protection class | For C-mount devices, only in combination with protective tube
|
| Explanation of protection class | For C-mount devices, only in combination with protective tube
|
| Vibration and shock resistance | EN 60068-2-6, EN 60068-2-27
|
