Features
- Non-destructive, precise measurement of the electrical conductivity of non-ferrous metals
- Measures according to DIN EN 2004-1 and ASTM E1004
- Used with probe FS40, the handheld device meets the Boeing specification BAC 5651
- High-resolution touchscreen display with virtual keyboard and user-friendly graphical user interface
- Various measurement frequencies for different penetration depths, from 15 kHz to 2 MHz, depending on the probe
- Operating temperature: 0 – 40 °C
- Measurement range: 0.3 – 63 MS/m or 0.5 – 108 % IACS
- Accuracy at room temperature: ± 0.5 % of the measured reading
- Takes into account the temperature coefficient of electrical conductivity valid for each individual material
- Automatic curvature compensation for known curvature diameters (down to the smallest diameter of 6 mm)
- Manual temperature input and monitoring of temperature change over time (ΔT/Δt)
- Enough memory for thousands of measuring applications and several thousand readings
- Certified reference standards (in MS/m, % IACS) – traceable to internationally recognized calibration standards
Applications
- Conductivity testing on raw materials for sorting and quality assurance
- Inspection of alloys in coinage (e.g. conductivity of Euro coins)
- Assessment of the hardness and strength of heat-treated materials
- Checking for heat damage, material fatigue and cracks
- Estimation of the phosphorous content in copper alloys or copper-bearing materials
- Tracking of precipitation processes, e.g. in Cu-Cr alloys
- Verification of the homogeneity of alloys
- Scrap sorting
The solution for electrical conductivity measurement
The SIGMASCOPE® SMP350 is a compact handheld device for measuring the electrical conductivity of non-ferrous metals. It quickly and accurately measures the electrical conductivity of aluminum or copper. From the measured conductivity, you can then draw further conclusions about the hardness and strength of heat-treated materials. This lets you monitor the material stability of components that are exposed to large temperature fluctuations. Even heat damage and material fatigue can be determined simply this way.
To measure the electrical conductivity, the device employs the phase sensitive eddy current method (according to DIN EN 2004-1 and ASTM E1004). This type of signal evaluation enables non-contact measurement, even under paint or plastic coatings up to 500 μm thick. It also minimizes the influence of surface roughness.
US 8308 
GB 7809 
CA 7095 
AU 6971 
IE 4142 
BR 3106 
VN 2920 
NZ 2299 
