Seco Minimaster for 3D milling is available in 2- and 3- flute versions, with 3-flute version it is possible to improve the productivity with higher feed rates, and with 2-flute version it is possible to minimize the risk of vibration.
Seco have continuously improved and extended the Minimaster range since its introduction in 1988. Today the Minimaster range is close to perfect, a unique end milling system which can combine different solutions due to the big range of inserts and shanks.
The Minimaster system consists of a broad range of different shanks and inserts types. There are no other end milling systems, which are more flexible and varied as Seco Minimaster. There are more than 600 combinations of inserts and shanks for each diameter between 6 and 20 mm.
VERSATILE AND COMPETITIVE
Minimaster is a two
piece design where you can combine shanks and inserts depending on the
application, which makes Minimaster the most versatile end mill system
on the market. This also means that with Minimaster you are able to find
a solution for almost every application. Minimaster is a stable and
rigid system and there is always a combination to minimize the overhang,
and attain maximum stability.
PRODUCT ADVANTAGES
When using Minimaster you have
a big advantage in the two piece design. When the insert is worn out
you just put another insert in the shank and you are ready for action
again. Minimaster is also an economical solution since you are not
paying for more solid carbide than that which is in use.
PRODUCT RANGE
Minimaster is available from 6–20
mm in diameter. The inserts can be ordered in many different versions
like under sized inserts for keyway, square shoulder inserts with sharp
edges or corner radius. Center drilling, Chamfering 45–60° Or double
chamfer, high feed inserts, Plunge milling and copy milling inserts in
90–120° ball nose versions.
