This is an Optical-Electrical-Optical (OEO) signal converter, which has two SFP sockets. It can convert two optical digital signals of SFP modules, which maybe different wavelength, different distance or different mode (single mode/multi mode fiber) and same speed at 100M Hz or 1G Hz auto detection. It allows the operator to maintain the Optical-Electrical-Optical with IEEE 802.3ah Link Layer OAM and TS-1000 OAM at CO or CPE mode.
Feature
- Protocol transparent 3R fiber media transponder/repeater (Re-amplification, Re-shaping and Re-clocking)
- Data rates up to 1G
- Extend transmission distance from fiber
- Perform optical repeater function
- Support SFP DDM (Digital Diagnostics Monitoring)
- Comply with IEEE 802.1Q Tag VLAN
- Support Q-in-Q function
- Maximum Frame size 9K bytes
- Ethernet bandwidth Control
- LED indicators for ease of network diagnostic
- Prompt indication on network failure
- Firmware upgrade via HTTP
- Built-in IP-based WEB GUI configuration and maintenance
- Centralized install with iEAC-16 via web or SNMP management
Specification
Model
- ENTU 763S/GO Stand alone Ethernet repeater
- ENTU 763C/GO Card type Ethernet repeater
Network Interface
- Connector type: SFP (MINI-GBIC)
- SFP type: 100Base-FX SFP modules
- 1000Base-X SFP modules
- Support SFP DDM (Digital Diagnostic Monitoring)
- Temperature, Voltage, Current, Tx Power, Rx Power
- For detailed wavelength and distance of SFP modules, please refer to SFP Transceivers datasheet
User Interface
- Connector type: SFP (MINI-GBIC)
- SFP type: 100Base-FX SFP modules
- 1000Base-X SFP modules
Ethernet feature
- Link Status
- Management IP: static IP or DHCP
- Ethernet bandwidth control
- Complies with IEEE 802.1q Tag VLAN (including Q-in-Q)
- Jumbo frame to 9k bytes
Management & OAM Functions
- Configuration via craft port VT-100 and WEB GUI
- Console: RJ45 connector (RS232C)
- HTTP firmware upgrade
- RMON counter
- Front panel test button for easy loop healthy testing
- Reset button back to factory default
- Support IEEE 802.3ah Link Layer OAM(network side)
Auto discovery
Link monitoring
Remote loopback test
Remote fault detection
- Link Fault Reflection
- Dying Gasp
- Critical Event
- Support TS-1000 OAM(network side)
Loopback test
Reset remote device
Get remote device information
Remote port setting
LED Indicators
- PWR, WAN LNK, CO, TST, TP, RF, LAN LNK
Power Requirement (Stand alone)
- AC/DC, DC/DC external power adapter (12V, 0.5A)
- Power consumption: 3.3W
Dimension
- 87(W) x 172(D) x 24(H) mm
Operating Environment
- Operation Temperature: 0 o C ~ 50 o C
- Storage Temperature: -20 o C ~ 70 o C
- Humidity: 90%, non-condensing
US 1098 
MY 550 
CN 115 
AP 67 
AU 51 
CA 31 
SG 27 
GB 25 
