Ambient temperature Ethernet sensor with two relay outputs.
Sensor H0530 is designed for online monitoring of temperature. Three binary inputs to detection of two-states signals are the advantage. Other devices are controlled by two relay outputs.
Included in delivery:
- H0530 sensor
- Traceable calibration certificate
- Quick start manual
- Technical support at discussion forum
| Technical parameters | Value |
|---|---|
| Output | Ethernet |
| Measured Value | Temperature |
| Construction Type | Ambient Air |
| Design | Industrial |
| Temperature Measuring Range | -30 to 80 °C |
| Relay Output | Yes |
| Two-State Input | Yes |
| Lcd Display | Yes |
| PoE | No |
| Accuracy of temperature output | ±0.4°C |
| Resolution | 0.1°C |
| Measuring interval | 2s |
| Available temperature units | degrees Celsius, degrees Fahrenheit |
| Temperature operating range | -30 to +80°C |
| IP protection | IP40 |
| Number of relay outputs | 2 |
| Maximum switching voltage, current and power of the relay output | 50V, 2A, 60VA |
| Number of binary inputs | 3 |
| Signal for binary inputs |
dry contact, open collector or two-state voltage signal. Inputs are not galvanically isolated. |
| Minimum pulse length at binary input | 500ms |
| Low voltage level at binary input | 0 to +0.5V |
| High voltage level at binary input | +3.0 to +30V |
| Audible alarm | built-in beeper - switchable |
| LAN connection | RJ-45 connector, 10Base-T or 100Base-TX |
| Communication protocols | WWW, ModbusTCP, SNMPv1, SOAP, XML |
| Alarm protocols | E-mail (SMTP authentication is supported), SNMP Trap, Syslog |
| Configuration | WWW interface, T-Sensor |
| Temperature operating range of LCD display | readable to operating temperature +70°C, it is recommended to switch OFF the LCD over +70°C |
| Power | 9 to 30Vdc, maximum consumption 1W |
| Power connector | co-axial, diameter 5.5 x 2.1mm |
| Dimensions | 136 x 191 x 45mm (W x H x D), stem length 53mm |
| Weight | approximately 340g |
US 846 
MY 369 
CN 324 
KR 90 
AU 58 
AP 57 
GB 40 
DE 31 
