HAND / MANUAL GREASE PUMP

OPERATION INSTRUCTIONS : When move the operation rod , the plunger ( iron core ) will be moved simultaneously so as to make cylinder become under negativepressure . Then , due to closed air pressure of the plank , the grease will get into the cylinder from the suction port . Now , operate the operating rod to extrude out the grease through pipe in the cylinder by principle of the plunger pushing open the specific pressure of 100kg/cm2 , down pressure valve will strart to eturn the grease to the oil tank . The operationg rod is to use of a spring to link on the injeector as a round storage tank to prevent from oil leaking.

ADVANTAGES : 1. Manual type pump . Use of single pipe , so no need of pipe return device . With simple piping for best effect . 2. Has smooth stickness to the lubricating surface with proper oiling capacity , so no surplus oil will be leaked out to stain with the surface of bench . 3. No need to worry about the dirts & impurities entered into the oiling port , so it is more clean than other ways of lubrication.

SPECIFICATION TABLE : Spec. Oil Outlet Capacity Output Pressure grease distributor max. SK-224-T03 Grease oil 2 cc / stork 300 cc 100 kg / cm2 SD 60 SK-224-T08 800 cc 100 kg / cm2 SD 60

Contact our sales consultant in area: 
Malaysia, Selangor (Klang, Puchong, Shah Alam, Subang), Kuala Lumpur (Sungai Buloh), Negeri Sembilan (Seremban), Melaka, Johor (Johor Bharu, Muar, Batu Pahat), Pahang (Temerloh, Kuantan), Kelantan (Kota Bahru), Terengganu (Kuala Terengganu), Perak (Ipoh), Kedah (Sungai Petani), Perlis, Penang (Bukit Mertajam, Butterworth, Seberang Prai), Sabah (Kota Kinabalu), Sarawak (Kuching), WP Putrajaya, WP Labuan, Indonesia, Singapore, Thailand, Philippines, Vietnam, Laos, Myanmar, Cambodia, Brunei