SENTROCOAT C, M, CM high emissivity coatings (water-based)
The SENTROCOAT line of water-based high emissivity coatings are blackbody formulations designed to significantly improve the thermal efficiency of radiant section tubes of furnaces, heaters and boilers in the Oil & Gas industries.
Energy savings in the range of 3–10% are typical using our coatings.
SENTROCOAT CP-1, CP-2 corrosion resistant coatings (solvent-based)
SENTRO’s Corrosion-Resistant Paint SENTROCOAT CP series coatings are formulated using an advanced solvent-based silicone resin combined with inorganic fillers and pigments
to offer continuous temperature resistance to 1100 °F (593 °C) and intermittent resistance to 1200 °F (649 °C).
These coatings are single-part, heat curable systems that adhere to a wide range of materials including metals, ceramics, glass, quartz, and refractories, and offer outstanding resistance to outdoor weathering, UV light, salt spray corrosion, oxidation, some chemicals, and thermal shock.
SENTROCOAT CP Line HIGHLIGHTS
SENTRO’s Corrosion-Resistant Paint SENTROCOAT CP series coatings are formulated using an advanced solvent-based silicone resin combined with inorganic fillers and pigments
to offer continuous temperature resistance to 1100 °F (593 °C) and intermittent resistance to 1200 °F (649 °C).
These coatings are single-part, heat curable systems that adhere to a wide range of materials including metals, ceramics, glass, quartz, and refractories, and offer outstanding resistance to outdoor weathering, UV light, salt spray corrosion, oxidation, some chemicals, and thermal shock.
SENTROCOAT CP Line HIGHLIGHTS
- Single-Part, No Mixing
- Low Viscosity
- Maximum Use Temperature, 1100 °F (593 °C)
- Intermittent Use Temperature, 1200 °F (649 °C)
- Bonds to Ceramics, Glass, Quartz, Metals
- Excellent Resistance to Moisture & Salt Spray
- Resists Thermal Shock
- Resists Ultraviolet Light
- Good Chemical Resistance
- Solvent-Based
Photo Gallery
Coating application of SENTROCOAT M (high-emissivity) in action
Step I : sandblast surface cleaning till “near white metal” of a furnace coil
Step II: applying 1st layer
Step III: applying 2nd layer
Step I : sandblast surface cleaning till “near white metal” of a furnace coil
Step II and III: applying 1st and 2nd layers
Measurement of Wet film thickness
Measurement of Dry film thickness
US 1048 
MY 868 
CN 255 
AU 69 
AP 67 
DE 46 
SG 42 
NZ 36 
