Cap Torque Tester

Cap Torque Tester

The new cap torque tester accurately measures twist on and twist off force.
The tester offers programmable high/low setpoints for go/no-go testing.
ORANGE lights up for measurements less than Low setpoint, GREEN for between High and Low setpoint, and RED for over High setpoint.
Store up to 1000 values in memory, which can be transmitted using the serial output.
Use the real time mode to display torque transients, or peak mode to capture the peak torque achieved during a test.
Selectable measuring units of lbf-in, kgf-cm, or N-cm.
Meet the standards: ASTM D2063, D3192, D3198, D3968, D3469, D3472, D3474, D3810.

Features
The overall aluminum die-casting mold design , sturdy and reliable , stable measurement data .
Special fixture design , non-slip , anti- vibration , lightweight .
Analyte weight and the vertical force is supported by the two ball bearings .
Through four clamping mouth piece , it is easy to sandwiched sample.
Digital display shows clockwise and counterclockwise torque and peak torque.
Comparator function which can program Hi/Lo set point.
Memory stores up to 1000 measurement.
Variety of outputs such as RS-232C, simulation and control signal output connected PC .
Selectable three units (N-m/Kgf-m/lb-in or N-cm/Kgf-cm/lbf-in)
AC power use

 

Technical data
Measuring unit: N.m Kgf.m Lbf.in or N.cm Kgf.cm Lbf.in
Display: 4 digits LCD
Comparator LED
Sampling rate:1000 times/sec
Overload capacity:150%(LED flash and buzz at 110%)
Accuracy :+/- 0.5 % of rated capacity
Operating temperature:0 to 40 degree Celsius
Outputs :RS-232C Mitutoyo Digimatic Analog voltage +/-2V,
Comparator signal (+NG,OK,NG)Open collector max.30VDC 10 mA
Over torque warning signal (OVL) Open collector max.30 VDC 10 mA
Weight:Approx. 4.5 kg

Specifications