CHINT DIGITAL POWER FACTOR METER PH7777 Malaysia Thailand Singapore Indonesia Philippines Vietnam Europe USA

To measure and display the single/three phase power factor meter in the electric lines with digital direct reading method. And can provide over-limit alarm output、transmitting output and communication output functions according to clients’ needs. There are programmable keys on the panel, can look up the current frequency and power factor angle by pressing the keys, which can program and set parameters including transformer rate、upper and lower limit alarm value、communication address of the meter、communication baud rate、transmitting output method、transmitting output range, etc. parameters.

Note: the size code 1,3,7,8 can be collocated 3 functional modules at the same time, the size code 2,5,6 can only choose one functional module optionally.

Basic parameters

Power factor measuring display range: 0.000C~0.500C~1.000~0.500L~0.000L

phase measuring display range: 0~359.9º

Accuracy: class 0.5 after converting to angle

input voltage: AC100V±10%;220V±10%、380V±10%

Input current range: 1A~5A

Auxiliary power supply: AC/DC 86~264V

alarm output(optional): relay contact output, the capacity of contact is AC250V/2A、DC30V/2A

Communication interface(optional): RS-485 serial communication, MODBUS_BTU communication protocol,

baud rate 1200bps、2400bps、4800bps、9600bps、19200bps.

transmitting output(optional): can be set among (0~10)mA、(0~20)mA、(4~20)mA, there is electrical isolation between the output port and signal input&auxiliary power port.

Load resistance of transmitting output: ≦500Ω