S 220 DEW POINT SENSOR/ dew point transmitter (-100 … 0 ºC)
The CS-iTEC dew point sensor S 220 provides reliable and long term stable dew point monitoring in industrial applications. CS is using a new sensor technology which has superior signals at very low moisture levels thus providing reliable measurements down to –100 ºC.
A stainless steel mesh filter with pore sizes below 30 um protects the sensor from particles. It’s designed for applications where very low moisture levels needs to be detected.
The measured dew point is output through a 4-20 mA signal (3-wire or loop powered). Sensor parameters such as analogue output scaling, physical units, can be easily changed by using CS-iTEC service kit.
Application
Stated accuracy under following conditions:
- Ambient temperature 23±3°C
- Process temperature 23±3°C
- Ambient humidity <95%, no condensation
- Airflow > 2 l/min at sensor tip
Product features
- Small size makes it ideal for dryer installations
- Measures dew points down to –100 ºC
- New CS-iTEC sensor technology
- Version with integrated pressure measurement
- Various output versions available: 1 x 4…20 mA, 2 x 4…20 mA, RS-485 (Modbus), 4…20 mA loop powered
- Very fast response time ensures safe and reliable indication whenever dew points are out of valid ranges
- IP65 casing provides robust protection in rough industrial environment
- Can be installed directly into dryers through G 1/2” thread
- High accuracy of 2 ºC dew point
- M12 connector
Technical data
| Measuring range | Dew point: -100 … 0 ºC Temperature: -30 … + 70 ºC Pressure: -0.1 … 1.6 MPa |
| Accuracy | Dew point: 2 ºC (-20 … -100 ºC ) Temperature: 0.3 ºC Pressure: 0.05 bar |
| Pressure range | -0.1 … 1.6 MPa |
| Power supply | 12 … 30 VDC / 30 mA |
| Measured gas | Non-corrosive gases |
| Ambient conditions | 0 … 50 ºC |
| Transport temperature |
-30 … +70 °C |
| Response time [90%] (at 4 l/min, perforated cap) |
-80 …-20 °C: 20 sec -20 … -80 °C: 3 min |
| Output signal | 4…20 mA, 3-wire (0699 0220, 0699 0221, 0699 0223) Modbus / RTU (0699 0222, 0699 0224) Loop powered 4…20 mA (0699 0025) |
| Analog output scaling | 4 mA –> -100 °C 20 mA –> +20 °C |
| Connector | M12, 5 pole |
| Wire sizes | Connector terminals support 0.14 … 0.25 mm² |
| Casing | Process connection: stainless steel Casing: Zinc alloy |
| Classification | IP65 |
| Process connection | G 1/2” thread (ISO 228/1) |
| Sensor protection | A: stainless steel sinter filter, pore size < 30 um B: Perforated sensor cap (standard, requires a prefilter 0.1 um) |
| EMC | According to IEC 61326-1 |
